• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x DryBoat 12 - DH1211 INOX (110V) 12 Litre Desiccant Dehumidifier1 x ZAP 710-61 Plate axial fan1 x Elta SLC400/4-3AC - IP551 x CC-ATEX 504 B Short Cased Axial Fan1 x 220x90mm x 2m Insulated Rectangular Duct1 x Etaline 450mm D4 01 (Three Phase)1 x CAB-400 ECOWATT Energy Efficient Acoustic Box Fan1 x HCFT/4-630mm plastic impeller plate fan1 x Singleflow SSDL400-1EC1 x Elta SPA710/6-3EC1 x Spiral Ducting 1 meter - 80mm1 x Ducting T Piece Equal - 80mm1 x HRFD 400/4/2 Cased Axial Fan 400mm - 3 Phase1 x Revolution SLCX ATEX Long Cased Axial Flow Fan SLCX500/2-3B Three Phase1 x HRT/4-630/25-BPN C1 x Soler & Palau - HCBT/4-710/H - IP651 x Soler & Palau TCBB/4-400/H - IP441 x 220x90mm Insulated Rectangular Horizontal 45° Bend1 x HRFD 315/4 EX Atex Rated 315mm Cased Axial Fan 400v1 x HRB/6-630-30-APN1 x 1mtr Round Ducting - 100mm1 x HCFT/6-630mm plastic impeller plate fan1 x Elta SCP710/4/6-3AC - IP551 x Flanged Spigot - 80mm1 x Elta SLC400-1EC -IE5 Motor- IP551 x AKOR Spare Filter1 x Ancillary Pack for SLC-900 for SLC900/4B-3AC1 x Elta Unpodded Silencer Melinex 1D-560mm1 x Atex Motor Protection Switch - U-EK230E EX1 x Elta SLC560/2-3AC - IP551 x Duct Termination with Mesh - 200mm1 x Elta SLC710/4B-3AC - IP551 x Ducting Reducers Short - 355mm-315mm1 x Female Ducting Connector - 710mm1 x HRST/6-800/28-AQ C21 x Raptor SDA560/46-3AC1 x KV DUO 150 EC1 x HRT/6-800/28-BZN-68C1 x Elta Quietflow Twin SQT500-3ECL1 x Sentinel D-BOX 150S/CP1 x HV Wall Mounted Belt Drive Fan 800mm 400V / 50Hz 0.75kW - Three Phase1 x AW Sileo EC Plate Axial Fan - Three Phase - 560mm1 x Duct Mounted Filter Box - G4 Grade Panel - 355mm
Reviews
TD-SILENT 350/125
TD-SILENT 350/125
£ 170.17

Excellent low noise fan, I've got one unit running years and...