• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
2 x Soler & Palau - HCBT/4-1000/L - IP551 x Soler & Palau - HCBB/4-450/H -IP65 - BFLOW1 x Helios HQW-450/4 - IP551 x HCFT/6-1000-HX plastic impeller plate fan1 x 150mm - 100mm Round Reducer1 x Hydor HPA450/6-1A1 x HRB/4-450-30-APN1 x Elta SPA450/46-3AC - IP541 x HCFB/4-450mm plastic impeller plate fan1 x TCDH-EXD Atex roof mounted Series1 x TCDH-EXD Atex roof mounted Series1 x 400mm x 400mm Metal Grille Box - 250mm Side Entry1 x HXP450/4-3 - 4 Pole - Three Phase1 x 100mm Wall Duct - 350mm1 x 100mm Round 45 Degree Bend1 x HCFT/4-450mm plastic impeller plate fan1 x 100mm - 125mm Round Reducer1 x HRB/4-450-35-BPN1 x Jetflow-HIT Metal inline - 125mm1 x 100mm Round Wall Plate1 x HIMF - Mixed Flow Fan 125mm Inline Fan1 x HRT/4-450/35-BPN1 x 45JMP/16/4/5/3/3ph Plate Fan1 x Insulated extract Plenum 6+11 x "VX100" - Standard Bathroom Axial fan - 100mm1 x DV-ROF-V-315 Roof mounted unit1 x HIMF - Mixed Flow Fan 100mm Inline Fan1 x Ancillary Pack for SLC-800 for SLC800/6A-3AC1 x Curved boot - 300mm1 x Inline Hepa filter with housing & pre-filters1 x Acoustic Box Fans (Inline) - CAB-250N1 x CBMT/Q 315-54 1 HEATER KIT1 x CBP-DC 15/151 x Male Ducting Connector - 400mm1 x Elta SLC1000/4B-3AC - IP551 x LCA403226 - Long Cased Axial Fan1 x Vent Axia KAF Kitchen Extract Fan - 500mm - 2 Pole - Three Phase1 x GB-WK Wall Bracket For Giga Box Fans - 400-630mm1 x ACQ-25012D Acoustic Inline Box Fan1 x Ancillary Pack for SLC-800 for 4 Pole and SLC-800/6B-3AC1 x Soler & Palau - HCBT/4-315/H - IP651 x Soler & Palau TCBB/4-560/H - IP651 x HXP500/4-3 - 4 Pole - Three Phase
Reviews
Soler & Palau TCBB/4-450/H - IP65
Soler & Palau TCBB/4-450/H - IP65
£ 481.79

Delivered super promptly yesterday, next day. Only just fitt...