• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Elta Variable Speed Drive IP66 - 7.5KW1 x Elta Variable Speed Drive IP66 - 1.5KW1 x Elta Variable Speed Drive IP66 - 4.0KW1 x Frequency converter RUCK - FU 075 201 x Frequency converter FU 075 14 - IP661 x Elta Variable Speed Drive IP66 - 0.75KW1 x FU 075 52 Frequency Inverter (IP20)1 x FU 22 25 Frequency Inverter1 x FU 15 40 Frequency Inverter1 x FRQ5-4A V2 Inverter Speed Controller1 x FRQ-10A V2 Inverter Speed controller1 x Helios TSD 3.0 Transformer Speed Control (400v)2 x Elta Variable Speed Drive IP66 - 2.2KW1 x PCA Diffuser - PCA-3151 x Helios - FIUK-11KW 24.0A - FREQUENCY INVERTER1 x FU 075 04 Frequency Inverter (IP20)1 x Frequency converter RUCK - FU 075 211 x FU 22 04 Frequency Inverter1 x NKS-D swirl diffuser v-300 x 300mm1 x ELTA - Three Phase Transformer 3amps1 x Elta Variable Speed Drive IP66 - 2.2KW (1ph to 3ph)1 x ELTA - Three Phase Transformer 10amps1 x ATEX rated 3-phase Speed Control - R-DK4 KT (EX)1 x FRQ5-10A Inverter Speed controller1 x FU 15 16 Frequency Inverter1 x Elta Variable Speed Drive IP66 - 5.5KW1 x Elta 10 Amp Electronic single phase speed controller.1 x Curved Blade Grille 600x600 (2way blow)1 x Round ceiling diffuser 400mm1 x Balance S Diffuser - NO RING - 125mm1 x Circular Ceiling Diffuser - TST 2001 x Circular Ceiling Diffuser - TST 1001 x Balance S Diffuser - NO RING - 100mm1 x EC6H - Reversible Group Fan Electronic Controller1 x Circular Ceiling Diffuser - TST 1602 x Electronic extractor fan speed controller - FSC 1.51 x JSR 200 Painted RAL50181 x ELTA - Single Phase Transformer 8amps1 x Round ceiling diffuser 300mm1 x ELTA - Single Phase Transformer 16amps1 x Elta 6 Amp Electronic single phase speed controller with TK2 x Elta 3 Amp Electronic single phase speed controller with TK1 x EFSC-3N- Single Phase Speed Control1 x Elta 2 Amp Electronic single phase speed controller.2 x Round ceiling diffuser 200mm1 x 5-Speed Controller for use with Elta SAX Classic Fans1 x ELTA - Single Phase Transformer 4amps2 x AIRVENT speed control - AIR4019611 x ELTA - Single Phase Transformer 12amps1 x Round ceiling diffuser 350mm1 x Airvent ceiling fan controller1 x Round ceiling diffuser 250mm2 x Elta 6 Amp Electronic single phase speed controller.1 x EFSC-6N- Single Phase Speed Control1 x PCA Diffuser - PCA-2502 x COM-31 x ELTA - Single Phase Transformer 10amps2 x Remote Timer Control - 13511 x Run On Timer - 5s - 4hrs - RT5A1 x Push Timer Switch - ZA42 x Helios ZNE Electronic Fan Overrun Timer1 x Time Delay Unit - DT20B1 x Multi Input Run On Timer - 0 - 20min - CFCU1 x 7 Day Programmable TIMECLOCK1 x EC-Vent Room Unit2 x Speed Controller - REB51 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 5001 x Easy-fix termination kit - High Rise Ventilator - EFT1 x Systemair Save Connect 2.0 Internet Module1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 6301 x Elta ACO Panel 149-ACO18B1 x EM30-24 Control Panel Commissioning Service1 x CBM 9-9 550w 4P VR (Open Motor)1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 3551 x REB-CVF 0-10v Controller1 x Elta Wall Cowl SWC56/631 x Elta Wall Cowl SWC35/401 x Elta Louvre Shutter - 400mm1 x Elta Wall Cowl SWC45/501 x GRA-100 External Grill by S&P1 x UB47- Universal Insulated Terminal1 x Elta Wall Cowl SWC25/311 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 7102 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt VR1 x Jet Cowl - 315mm1 x Vent Axia ACM 100 T (Timer Model) inline mixed flow duct fan1 x Helios TSW 10 Amp Transformer speed controller1 x Envirovent Silent MV160/100T Mixvent - Timer Model - 100mm - (5 year warranty)1 x BEAS-control module1 x MWS 1.5 – Transformer Controller With Motor Protection1 x TG-K3/NTC10-01 - Duct temperature sensor1 x CPTA-S PIR SENSOR Volt Free Contacts - Surface Mounted1 x Commercial Single or 3 phase Fan Reversing Switch - RS11 x MTS10- extractor fan 3 step switch1 x Quietflow SQS400-1ECL - Centrifugal Box Fan1 x Speed Controller - REB11 x Bathroom Fan -Envirovent- Silent 100 T (Timer Model)1 x MTP 10, 10K, Speed control1 x PIR Sensor - PIR21 x PIR Sensor - PIR41 x VTR 300 STD Filter Kit1 x Contactor Interface Station - CI91 x CBT-100N Centrifugal1 x Elta - Room Sensor - Temp/Humid/C021 x Mini Diffuser - 100mm1 x ACO8AC/EC AutoChangeover panel1 x Biflow SB400-CON2-3 - High Temperature Bifurcated Fan1 x CO2 Room Sensor - CO2-R1 x VTR 500 STD Filter Kit1 x Remote controller FLEX - for VEKO INT1 x S&P MULTI-REG EC FAN CONTROLLER / INTERFACE1 x Helios TSW 7.5 Amp Transformer speed controller1 x REU 1.5amp Speed control - Two Speed Five-Step Transformer - Trickle and Boost1 x Transformer 5 Speed Controller - ATC1-10TK1 x Transformer 5 Speed Controller - ATC1-12TK1 x HCFC 1.7 - Reversible Speed Controller for HCF sweep fans
BD7/7 centrifugal M4 0.13Kw
BD7/7 centrifugal M4 0.13Kw
£ 345.00 now £ 300.00
Reviews
Duct Mounted Inline Filter - EU4
Duct Mounted Inline Filter - EU4
£ 44.99

Well made and robust, but it was not use for my application ...