• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Flanged Spigot - 100mm1 x Rosenberg ATEX DKHM 355-4SW.110.5DF-E751 x Duct Fast Clamps - 355mm1 x Ducting Y Piece - 355mm1 x AW 550 D6-2-EX Explosion Proof Axial Fan - ATEX1 x 24FLPIIB3-6PM1 x HQD 630/4 EX - ATEX Rated Plate Axial Fan (4-pole)1 x Elta Raptor SFB ATEX Plate Mounted Axial Fan- 560mm1 x FlameProof Plate Axial Fan - Single Phase - 10.5 inches - Eexd IIC T4 -2pole1 x DKEX 355-6 Centrifugal High Performance ATEX Fan1 x FlameProof Plate Axial Fan - Single Phase - 9 inches - Eexd IIC T4 -2pole1 x Helios AV100 External Wall Fan1 x CBT-130N Centrifugal ATEX II 3D ExtD 125*C1 x HV STYLVENT Wall Kit Threaded Rods1 x CBT-130N Centrifugal ATEX II 2G Exe II T31 x CBT-100N Centrifugal ATEX II 2G Exe II T31 x DKEX 315-4 Centrifugal High Performance ATEX Fan1 x CBT-100 N (230/400V50HZ) LG270-EXDIIBT41 x RVK-EX 315D4 (ATEX) - 315mm Atex Rated Centrifugal Fan1 x EX 140A-2 (Three Phase) Centrifugal Fan (ATEX)1 x CBT-130N Centrifugal ATEX II 2G Exd IIB T41 x HQD 315/2 EX - ATEX Rated Plate Axial Fan (2-pole)1 x Elta EC Electronic Controller1 x 100mm Round Condensation Trap1 x FlameProof Plate Axial Fan - Single Phase - 12 inches - Eexd IIC T4 -4pole1 x Elta Raptor SFB ATEX Plate Mounted Axial Fan- 650mm1 x GX6EC - High Performance Extract Fan1 x Three Phase ATEX Compact axial fan - 315mm - compactATEC41 x HXP450/6-1 - 6 Pole - Single Phase1 x AL 355 D2 01 - High Performance Long Cased Axial Fan1 x Soler & Palau TCBT/6-400/H - IP441 x Clearflow CFHT Kitchen/High Temp Roof Fan - CFHT350/4-3AC1 x ACO3/BD Changover Panel (Three Phase)1 x Belt Drive Cased Axial Fan - 800mm - H version1 x Soler & Palau - HCBT/4-1000/L - IP551 x KABT High Temp Acoustic Kitchen Fan & Inverter Kit - KABT/4-3000/315 ND - Pack 11 x Spare filter for Energi Sava 200 & 250 HR unit1 x M8 x 3M Z/P Studding1 x *VORT HRW 30 MONO Evo HCS WIFI - Single Room Heat Recovery Unit,1 x Genius Whole house unit -1 x Elta Turboflow-TF - 500mm(B) - Three phase1 x Ducting Y Piece - 125mm1 x Jetflow-HIT Metal inline - 250mm1 x 1mtr Round Ducting - 100mm1 x 220x90mm Equal T Piece1 x HR-500 DP Heat Exchange Unit1 x Flanged Spigot - 150mm1 x Elta SLC500/4A-3AC - IP551 x Raptor SDA500/6-1AC
Reviews
EM 250-E2M 01- Etamaster-250
EM 250-E2M 01- Etamaster-250
£ 128.80

Really well made but comes with no speed controler? ?and can...