• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x ELM 18 EX Flexible Cuff for ERM 182 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt VR1 x VTR 300 STD Filter Kit2 x CSB-60 Centrifugal fan4 x Helios ESA-1 Surface mounted Speed Control 1amp2 x CBT-100N Centrifugal2 x Flakt Woods ME 1.6 speed controller 6.0amp - EA9011591 x Singleflow SSDL315-1EC1 x Biflow SB400-CON2-3 - High Temperature Bifurcated Fan2 x CBM Low Pressure Centrifugal Fan - CBM 9/7 4 Pole 373watt CVR4 x CBA-100 Inlet Flange for CBT-1002 x HIMF - Mixed Flow Fan 100mm Inline Fan1 x Single Deflection Grille 400mm with OBD damper1 x TUNE-R-200-3-M0 - Control Damper (NO ACTUATOR)1 x CBM 12-12 1100w 6P Three Phase1 x SD-MUB Vibration pad set1 x WSD 100 (1060x1060x70)1 x Silentub - STUB 1002 x SPI-100 C Iris damper1 x SAVE VSR 300 heat recovery unit2 x CCpro 40 (1CC9402) Long Casing Extension3 x Helios RR-250-C Centrifugal inline fan1 x RD35S-4DW.6W.3L - 122297 (Three Phase)1 x ACO8AC/EC AutoChangeover panel1 x CBT-130N Centrifugal ATEX II 3D ExtD 125*C3 x DDMP 12-12 3F 5700W M6M0 DG71 x Helios HQW-355/4 - IP552 x VTR 500 STD Filter Kit1 x Comefri - TLZ 450 R - High Performance Scroll Fan1 x Duct Termination with Mesh - 355mm1 x CBM Low Pressure Centrifugal Fan - CBM 12/12 6 Pole 736watt CVR1 x Duct Termination with Mesh - 100mm1 x IR24-P - Presence detector1 x DEF-CBM-RE-7 - Protection Guard2 x CMT-2 120/50 - 0,09Kw - LG270 Single inlet centrifugal fan direct driven2 x KAD-225-F400 Rectangle Flexible Connector2 x 100mm Round Connector with Damper1 x Non Vision 150mm x 150mm (Air Transfer) Grille - With Flange - MILL FINISH2 x DDMP 10-10 1F 1000W M6A2 DA51 x CBT-80N Centrifugal2 x CBB-60N Centrifugal1 x Quietflow Twin SQTDCV250-1ECL1 x Flakt Woods ME 1.1 speed controller 1amp - EA9011571 x Flakt Woods ME 1.3 speed controller 3amp - EA9011581 x CFI In-line 150 - Carbon Filter1 x TD160-NT Mixvent - 100mm - TD160 Timer2 x Duct Termination with Mesh - 450mm1 x KBA- Inlet Mounting 2252 x Duct Termination with Mesh - 150mm3 x DDMP 07/07 Mounting Flange2 x Flat Roof Terminal -OFT 5 - Asphalt2 x Potentiometer EGH 01 - for DDMP Fans1 x LFBR 160 G4 - Helios Inline Filter Box - 160mm3 x HIMF - Mixed Flow Fan 125mm Inline Fan1 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt 3V (3-Speed)2 x Mini Diffuser - 100mm1 x ACO3TO-ADS-VFC-7.1A1 x DA9/9-NT2 x ACOAS/ AC/EC Auto Changeover 8Amp2 x DDMP 12-09 1F 1800W M6A4 DA82 x CBS-100 Outlet Flange for CBT-1001 x Helios ZNE Electronic Fan Overrun Timer1 x VEKA INT 2000/15.0-L1 EKO1 x CMT/4-315/130-4KW - Single inlet centrifugal fan direct driven1 x FU 15 16 Frequency Inverter2 x DDMP 09-07 1F 1000W M6A0 DA51 x Remote Timer Control - 13511 x Speed Controller - REB2.5-N2 x ELTA - Three Phase Transformer 3amps1 x CBB-80N Centrifugal1 x CAD-COMPACT 900 ADVANCED N8 - MVHR unit1 x Vent Axia Trickle & Boost Switch1 x DPD 12PM Delivery Surcharge1 x RUCK MTP 20, 10K, Speed control1 x Comefri - TLZ 560 R - High Performance Scroll Fan1 x CBM 7/7 147w 4P RE-VR2 x CBM Low Pressure Centrifugal Fan - CBM 7/7 6 Pole 72watt CVR1 x Round ceiling diffuser 250mm1 x REU 3amp Speed control - Two Speed Five-Step Transformer - Trickle and Boost1 x EFSC-3N- Single Phase Speed Control1 x Commercial Single or 3 phase Fan Reversing Switch - RS11 x Elta Variable Speed Drive IP66 - 2.2KW1 x REB-CVF 0-10v Controller1 x Silent 300 CZ Design PLUS Extractor Fan1 x Skyflow SSR Horizontal Roof Cowl SSR80B1 x Elta 6 Amp Electronic single phase speed controller.1 x Speed Controller - REB161 x Lo-Carbon Silhouette 100T (Timer)1 x VKS 355-500 Automatic shutter1 x EBM-Papst D3G133-BF05-14 Double inlet1 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt C VR
Reviews
Duct Mounted Inline Filter - EU4
Duct Mounted Inline Filter - EU4
£ 44.99

Well made and robust, but it was not use for my application ...