• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Duct Fast Clamps - 315mm1 x 204x60mm Insulated Rectangular Vertical 90° Bend1 x Spiral Ducting 1 meter - 250mm1 x BF VVX-200 - Villavent Filter1 x FAST-TRACK RANGE 75mm - Click Ring (1 bag of 10)1 x 220x90mm 90 Degree Horizontal Bend1 x Soler & Palau TCBT/6-710/H - IP651 x Ducting 30 Degree Bend - 180mm1 x Elta 2 Amp Electronic single phase speed controller.1 x Jetflow-HIT Metal inline - 125mm1 x Jetflow-HIT Metal inline - 250mm1 x Circular Inline Silencers - 600mm - 600mm1 x EC-Basic-T temperature1 x Female Ducting Connector - 160mm1 x EuroSeries (ESP) - Plate Mounted Axial Fans 315-121 x KV DUO 400 EC1 x Impeller Side Guard - 315mm1 x Metal Inline Fan - VENT-250NK1 x Kitchen Grease Filter - Mesh Type Non standard 296mmx296mmx22mm1 x JETLINE-250 - In Line Centrifugal Duct Fan1 x Soler & Palau TCBT/6-355/H - IP441 x Helios GigaBox 400mm GBW 400/4 centrifugal1 x Differential Pressure Switch - 50 - 500 Pa - IP651 x EBB-250 HM DESIGN Centrifugal Extractor Fan1 x Ducting 90 Degree Bend - 160mm1 x Egg Crate Grille with Dust panel filter 1 inch- 595x5951 x Circular Ceiling Diffuser - TST 1251 x KV 250 L Sileo1 x FlameProof Plate Axial Fan - Single Phase - 9 inches - Eexd IIC T4 -4pole1 x ELTA - Single Phase Transformer 8amps1 x Spiral Duct Grille Termination - 500mm1 x CHVB/4-3000/315 0,27KW 230V50 VE1 x 220x90mm 45 Degree Horizontal Bend1 x HRSB/6-710/24-BZ1 x Elta SPA630/46-3AC - IP541 x EBB-250 S DESIGN Centrifugal Extractor Fan1 x CBM 12/9 CM/AL 1100W 6PT - Closed Motor1 x Biflow SB315-CON2-3 - High Temperature Bifurcated Fan1 x Spiral Ducting 3 Meters - 900mm1 x 220x90mm x 1m Low Profile Plastic Ducting - 1 Meter1 x CPTA-E Flush mounted PIR sensor with timer1 x Belt Drive Cased Axial Fan - 560mm - H version1 x CAB-250 ECOWATT Energy Efficient Acoustic Box Fan1 x Clearflow CF Roof Mounted Vertical Discharge Centrifugal Fan - CF400/4-3AC - Three Phase1 x Belt Drive Cased Axial Fan - 560mm - L version1 x Duct Quick Suspension Rings with Clasp - 315mm1 x Ducting Y Piece - 250mm1 x Hydor HPA315/4-1A1 x Elta SLC900/8-3AC1 x Elta Variable Speed Drive IP66 - 7.5KW1 x 110 x 54mm Flat Channel Clip (Pack Of 5)1 x Time Delay Unit - DT20B1 x Jetflow-HIT Metal inline - 150mm1 x 220x90mm Insulated Rectangular Horizontal 45° Bend1 x Belt Drive Cased Axial Fan - 800mm - G version1 x Shoed T Piece Un-Equal -450mm-315mm1 x Ducting 45 Degree Bend - 630mm1 x Duct Split Rings (Pair) -500mm1 x Helios ZNE Electronic Fan Overrun Timer1 x Elta SLC355/4-3AC - IP551 x Helios GigaBox 500mm GBW 500/4 centrifugal1 x Spiral Ducting 3 Meters - 400mm1 x AL 355 Mounting Feet (Pair)1 x Elta Unpodded Silencer Melinex 2D-450mm1 x Elta SLC1000/6A-3AC - IP551 x Duct Mounted Filter Box - 450mm - M6 grade Bag filter1 x Elta SCP315/4-3AC - IP551 x Biflow SB250-CON4-3 - High Temperature Bifurcated Fan1 x HRST/6-800/28-AQ C21 x Comefri - TLZ 450 R - High Performance Scroll Fan1 x Jetflow-HIT Metal inline - 160mm1 x 100mm Wall Duct - 350mm1 x 125mm Wall Duct - 350mm1 x Belt Drive Cased Axial Fan - 450mm - H version1 x Ducting T Piece Equal - 315mm1 x Elta SLC1000/8-3AC - IP551 x Ducting 30 Degree Bend - 250mm1 x Elta Raptor SFB ATEX Plate Mounted Axial Fan- 420mm1 x FU 15 40 Frequency Inverter1 x Run On Timer - 5s - 4hrs - RT5A1 x Acopel F400-710/1801 x 220x90mm x 1m Insulated Rectangular Duct1 x Ducting 30 Degree Bend - 450mm1 x Acopel F400-225/1601 x Ducting Y Piece - 500mm
Reviews
EM 250-E2M 01- Etamaster-250
EM 250-E2M 01- Etamaster-250
£ 128.80

Really well made but comes with no speed controler? ?and can...