• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Soler & Palau TCBT/6-710/L - IP651 x Xpelair GX9 commercial window fan1 x HIMF - Mixed Flow Fan 125mm Inline Fan1 x Spigot plate - 800mm1 x Duct Mounted Filter Box With G2 Paper AND Metal Washable Filter - 315mm1 x Spiral Ducting 3 Meters - 800mm1 x TD160 Mixvent - 100mm - TD160-N Standard1 x Helios AV100 External Wall Fan1 x EM 200-E2M 01- Etamaster-2001 x ELTA - Three Phase Transformer 3amps1 x Duct Suspension Rings - 100mm1 x FU 075 04 Frequency Inverter (IP20)1 x AES-Fire control unit1 x Atex Motor Protection Switch - U-EK230E EX1 x Differential Pressure Switch - 50 - 500 Pa - IP541 x DT-1 Duct Mounted Thermostat1 x Differential Pressure Switch - 20 - 300 Pa - IP541 x Commercial Thermostat - TH161 x Differential Pressure Switch - 20 - 300 Pa - IP651 x Differential Pressure Switch - 50 - 500 Pa - IP651 x B-flow Impeller HCBB/T-355mm1 x Helios GigaBox 500mm GBW 500/4 centrifugal1 x Purlin Box 630/710 for RAW Cowls1 x Jetflow-HIT Metal inline - 200mm1 x Jetflow-HIT Metal inline - 250mm1 x Jetflow-HIT Metal inline - 100mm1 x Ducting 90 Degree Bend - 900mm1 x Spigot plate - 900mm1 x Curved boot - 900mm1 x B-flow Impeller HCBB/T-450mm1 x EBM-papst Motorised Impeller - A6D800-AD01-011 x Etaline 450mm D4 01 (Three Phase)1 x Elta - SMT 125 Mixvent Inline Fan - Clearance Stock Line1 x F7/G4 filter kit for IDEO HR unit1 x DV-ROF-V-315 Roof mounted unit1 x Ducting 45 Degree Bend - 710mm1 x Helios GigaBox 450mm GBD 450 centrifugal - EC Motor1 x Air Quality Sensor - AQS1 x AKOR GD - Spare Motor1 x Elta Unpodded Silencer Melinex 1D-500mm1 x *VORT HRW 30 MONO Evo - Single Room Heat Recovery Unit,1 x Elta Unpodded Silencer 1D-560mm1 x FSAF1000B1DB Silencer 1043/241 x Etaline 500mm - D4 01 3 Phase
Reviews
Circular Inline Silencers - 0.6M long - SLU-600
Circular Inline Silencers - 0.6M long - SLU-600
£ 50.56

I have a loft mount extractor fan which was very noisy. I ...