• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x KV 250 L Sileo1 x 1mtr Round Ducting - 100mm1 x PRIO-160 160mm Inline Mixvent Fan1 x HV Wall Mounted Belt Drive Fan 1000mm 400V / 50Hz 0.75kW - Three Phase1 x Soler & Palau - HCBT/4-1000/L - IP551 x Curved boot - 900mm1 x MELL-USD 3000 Rectangular to Circular Adaptor 355 Dia1 x 100mm Round Wall Plate1 x Universal Pipe Fixing Clip1 x 100mm Round 90 Degree Bend1 x RS-160L1 x Etaline Max-Fan - 315mm - E2 011 x Spigot plate - 900mm1 x SG AW 1000 Guard 6-Pole1 x Mellizo XL EcoWatt 3000 - Twin Fan1 x PRIO-160 EC 160mm Inline Mixvent Fan1 x Ducting 45 Degree Bend - 80mm1 x Duct Fast Clamps - 250mm1 x Ducting 30 Degree Bend - 250mm1 x Duct Suspension Rings - 80mm1 x Clearflow CFHT Kitchen/High Temp Roof Fan - CFHT450/4-3AC1 x 220x90mm x 1m Low Profile Plastic Ducting - 1 Meter1 x Soler & Palau TCBT/4-400/H - IP441 x Elta SCP500/4-1AC - IP551 x HR-500 DP Heat Exchange Unit1 x Flanged Spigot - 100mm1 x CRBB/3-160/052M EC 1H0 MP - External Rotor Motor Radial Fans1 x F7/G4 filter kit for IDEO HR unit1 x Anti Vibration Duct Suspension Rings - 250m1 x Elta Wall Cowl SWC45/501 x Spiral Duct Grille Termination - 80mm1 x Miniflow SMF Horizontal Roof Cowl SMF131 x Ducting T Piece Equal - 80mm1 x Axial Roof mounted Extract/Supply Fan- -HCTT/4-1000-A 5.5kw1 x CC-ATEX 404 B M Short Cased Axial Fan1 x AKOR Mounting Plate for GD model(VIM166423)1 x Male Ducting Connector - 80mm1 x Flexible PVC Ducting - 220x901 x PBB/4-400 Portable Cooling Fan1 x HRB/6-630-30-APN1 x AKOR T3/7 Spare Motor1 x AW Sileo EC Plate Axial Fan - Three Phase - 710mm1 x TCBT/4-710/H EXDIIBT4 ATEX1 x Spigot plate - 80mm1 x AL 355 EC 01 AXIALINE - High Performance Long Cased Axial Fan
Reviews
Airvent Ceiling Sweep Fan - 36 inch - 444122
Airvent Ceiling Sweep Fan - 36 inch - 444122
£ 59.84

Fitted 2 Of These Excellent Fans in a Community Club to shif...