• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Additional Delivery Surcharge1 x HIMF - Mixed Flow Fan 150mm Inline Fan1 x Spiral Ducting 3 Meters - 180mm1 x Double Inlet Forward Curved Centrifugal Fans - FDA-160-SL D201 x Helios HQW-250/4 - IP551 x GX6 Wall Kit1 x Commercial Activated Carbon Filters - Panel Type - 20" x 20" x 1 - ACP1 x Ducting 90 Degree Bend - 250mm1 x KMBI 225 Connector rectangular/circular to install on the discharge of CMT1 x Kitchen Grease Filter - Mesh Type NON standard 290mm x 290mm x 47mm Actual1 x KBA- Inlet Mounting 2251 x CMT-2 225/090 1.1KW - Single inlet centrifugal fan direct driven1 x Digital Room Thermostat - DRT1 x Spiral Rapid Lock Clamp - 250mm1 x Ducting 90 Degree Bend - 80mm1 x Spiral Ducting 3 Meters - 100mm1 x Male Ducting Connector - 180mm1 x Acoustic Box Fans (Inline) - CAB-1001 x 100mm Round Connector with Damper1 x Double Inlet Forward Curved Centrifugal Fans - FDA-225-C1 x Double Inlet Forward Curved Centrifugal Fans - FDA-400-CM1 x EBM Papst Fan - W2E250-CE65-241 x CVTT-7/7 0.18Kw Belt Driven Cabinet Fan1 x Double Inlet Forward Curved Centrifugal Fans - FDA-180-SM D201 x EBM Papst- A4E 315-AC08-091 x CSB-60 Centrifugal fan1 x CXRT/4-630 5,5KW RD0001 x Dust Extractor - CMRT/2-221 0,181 x Double Inlet Forward Curved Centrifugal Fans - FDA-280-C1 x Ducting 15 Degree Bend - 100mm1 x EBM Papst- A4E 330-AP18011 x Dust Extractor - CMRT/4-631 5.51 x Double Inlet Forward Curved Centrifugal Fans -FDA 710 TM D55 VE1 x CPTA-E Flush mounted PIR sensor with timer1 x CVTT- Belt Driven Cabinet Fan1 x CST-60 (230/400V50HZ)1 x EBM Papst Fan - W2E300- CP02-301 x SCHT-AD Intelligent elements for demand controlled ventilation1 x Remote Humidistat - XRH1 x TG-K Duct temperature sensor1 x Presence Detector IR24-PC1 x Pulser Temperature control1 x TG-R room temperature sensor1 x Differential Pressure Switch - 20 - 300 Pa - IP541 x Air Quality Sensor - AQS1 x DTV200 - Differential Pressure Switch1 x *VORT HRW 40 MONO Evo HCS WIFI - Single Room Heat Recovery Unit,
Reviews
Circular Inline Silencers - 0.6M long - SLU-600
Circular Inline Silencers - 0.6M long - SLU-600
£ 50.56

I have a loft mount extractor fan which was very noisy. I ...