• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x 220x90mm Insulated Rectangular Horizontal 90° Bend1 x Run On Timer - 5s - 4hrs - RT5A1 x Duct Fast Clamps - 200mm1 x Universal Pipe Fixing Clip1 x 125mm - 100mm Round Reducer1 x Spiral Ducting 3 Meters - 200mm1 x 204 x 60mm Duct to Fitting Connector for use with Insulated Thermal Ducting1 x 125mm Wall Duct - 350mm1 x Elta Wall Cowl SWC25/311 x 110 x 54mm Short Rectangular to Round Adaptor Female1 x 2mtr Insulated Round Ducting - 125mm1 x 125mm Round Wall Plate1 x 110 x 54mm Flat Channel Connector1 x 220x90mm Mounting Clip (Individual)1 x Curved boot - 200mm1 x Ducting T Piece Equal - 200mm1 x Elta SLC900/4B-3AC - IP551 x 204x60mm Insulated Rectangular Vertical 90° Bend1 x 150mm Round Connector1 x GRA-100 External Grill by S&P1 x 100mm - 125mm Round Reducer1 x External weather louvre 250mm x 250mm in RAL 70211 x 125mm Thermal Duct to Duct Connector - SST-125-DDCON1 x Ducting Y Piece - 200mm1 x Belt Drive Cased Axial Fan - 900mm - H version1 x Flanged Spigot - 100mm1 x Spiral Duct Grille Termination - 200mm1 x Elta SLC900/8-3AC1 x Shoed T Piece Equal -200mm1 x 110 x 54mm Rectangular Wall Plate1 x Easy-fix termination kit - High Rise Ventilator - EFT1 x 220 x 90mm Duct to Duct Connector for use with Insulated Thermal Ducting1 x Ducting 45 Degree Bend - 200mm1 x Duct Quick Suspension Rings with Clasp - 200mm1 x JETLINE-200 - In Line Centrifugal Duct Fan1 x Ducting 90 Degree Bend - 180mm1 x FU 15 40 Frequency Inverter1 x PBB/4-400 Portable Cooling Fan1 x Cased Axial Fan Extension - 400mm dia1 x Elta Variable Speed Drive IP66 - 4.0KW1 x 150mm Round Connector with Damper
Reviews
Duct Mounted Inline Filter - EU4
Duct Mounted Inline Filter - EU4
£ 41.95

Well made and robust, but it was not use for my application ...