• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
2 x DEF-CBM-RE-7 - Protection Guard1 x Electrostatic Precipitator - 1H x 3W1 x Vertical Cowl and Fan (Single Phase) - RAV400-4-11 x VTR 300 STD Filter Kit1 x Contactor Interface Station - CI96 x ACO8AC/EC AutoChangeover panel3 x Duct Termination with Mesh - 100mm4 x Duct Termination with Mesh - 355mm2 x TUNE-R-200-3-M2 - Control Damper3 x Helios RR-250-C Centrifugal inline fan1 x AIRVENT speed control - AIR4019612 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt VR1 x Silentub - STUB 1002 x CBM Low Pressure Centrifugal Fan - CBM 9/7 4 Pole 373watt CVR5 x CBM Low Pressure Centrifugal Fan - CBM 12/12 6 Pole 736watt CVR2 x SAVE VSR 300 heat recovery unit2 x Flakt Woods ME 1.6 speed controller 6.0amp - EA9011591 x Round ceiling diffuser 200mm2 x SPI-100 C Iris damper2 x CSB-60 Centrifugal fan2 x CBT-130N Centrifugal ATEX II 3D ExtD 125*C4 x HIMF - Mixed Flow Fan 100mm Inline Fan2 x RD35S-4DW.6W.3L - 122297 (Three Phase)1 x Non Vision 150mm x 150mm (Air Transfer) Grille - With Flange - MILL FINISH1 x CK-60F Kit1 x WSD 100 (1060x1060x70)2 x TD160-NT Mixvent - 100mm - TD160 Timer3 x Round ceiling diffuser 250mm1 x Comefri - TLZ 450 R - High Performance Scroll Fan4 x Flat Roof Terminal -OFT 5 - Asphalt5 x Helios ESA-1 Surface mounted Speed Control 1amp4 x VEKA INT 2000/15.0-L1 EKO1 x CBT-100N Centrifugal4 x CBA-100 Inlet Flange for CBT-1005 x DDMP 12-12 3F 5700W M6M0 DG72 x SD-MUB Vibration pad set1 x Mini Diffuser - 100mm2 x CFI In-line 150 - Carbon Filter5 x Duct Termination with Mesh - 450mm4 x 100mm Round Connector with Damper7 x Helios HQW-355/4 - IP552 x DS-2 2-Speed Switch (3 Phase)2 x VTR 500 STD Filter Kit1 x ACO3TO-ADS-VFC-7.1A2 x Quietflow Twin SQTDCV250-1ECL2 x CCpro 40 (1CC9402) Long Casing Extension2 x Binks Bullows - Spray Booth Filter2 x ACOAS/ AC/EC Auto Changeover 8Amp3 x Singleflow SSDL315-1EC4 x DDMP 10-10 1F 1000W M6A2 DA52 x DDMP 07/07 Mounting Flange3 x Elta SCP400/4-1AC - IP552 x CMT-2 120/50 - 0,09Kw - LG270 Single inlet centrifugal fan direct driven1 x TUNE-R-200-3-M0 - Control Damper (NO ACTUATOR)3 x Duct Termination with Mesh - 150mm2 x DA9/9-NT2 x KAD-225-F400 Rectangle Flexible Connector2 x Flakt Woods ME 1.1 speed controller 1amp - EA9011572 x CBT-80N Centrifugal1 x DDMP 12-09 1F 1800W M6A4 DA82 x KBA- Inlet Mounting 2252 x KBA- Inlet Mounting 2504 x CBS-100 Outlet Flange for CBT-1002 x Elta HXP 800mm 6-Pole (Three Phase)2 x CBB-60N Centrifugal1 x FRQ5-4A V2 Inverter Speed Controller1 x REB-CVF 0-10v Controller1 x HIMF - Mixed Flow Fan 125mm Inline Fan3 x RUCK MTP 20, 10K, Speed control2 x Flakt Woods ME 1.3 speed controller 3amp - EA9011583 x DPD 12PM Delivery Surcharge1 x Commercial Single or 3 phase Fan Reversing Switch - RS11 x Speed Controller - REB1-N2 x CBP-18/18-RC Belt Driven Centrifugal Fans3 x ELTA - Three Phase Transformer 3amps2 x Elta SPA500/4-1AC - IP541 x Envirovent Silent MV160/100S Mixvent - 100mm - (5 year warranty)5 x Biflow SB250-CON4-3 - High Temperature Bifurcated Fan2 x RTRD - Three Phase Speed Controller - 2 Amp1 x Speed Controller - REB51 x Silent 300 CZ Design PLUS Extractor Fan3 x Elta Variable Speed Drive IP66 - 4.0KW1 x KBA- inlet mounting flange for CRMT 2502 x Clearflow CF Roof Mounted Vertical Discharge Centrifugal Fan - CF450/4-1AC - Single Phase2 x VKS 355-500 Automatic shutter1 x IR24-P - Presence detector2 x Comefri - TLZ 560 R - High Performance Scroll Fan1 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt 3V (3-Speed)2 x Biflow SB500-CON2-3 - High Temperature Bifurcated Fan1 x CBM Low Pressure Centrifugal Fan - CBM 7/7 6 Pole 72watt CVR1 x Capacitor 2uf for use with the EBM A4E range2 x EFSC-3N- Single Phase Speed Control3 x HXP450/6-1 - 6 Pole - Single Phase1 x CAD-COMPACT 900 ADVANCED N8 - MVHR unit3 x Duct Termination with Mesh - 250mm3 x Biflow SB315-CON4-3 - High Temperature Bifurcated Fan1 x TecFire Intumescent Damper - Rectangular 400x400mm1 x RDH Flange - 03151 x RDH Flange - 02501 x TD Mixvent 1100/250 EEXEIIT31 x Multi Input Run On Timer - 0 - 20min - CFCU1 x Elta Variable Speed Drive IP66 - 7.5KW1 x Skyflow SSR Horizontal Roof Cowl SSR80B1 x Round ceiling diffuser 400mm1 x FU 15 16 Frequency Inverter1 x ELTA - Single Phase Transformer 2amps1 x Potentiometer EGH 01 - for DDMP Fans1 x REU 3amp Speed control - Two Speed Five-Step Transformer - Trickle and Boost2 x Transformer Speed Control - RTRE- 3.0Amp1 x TUNE-R-200-3-M4 - Control Damper1 x EBM-Papst D3G133-BF05-14 Double inlet1 x Comefri - TLZ 225 R - High Performance Scroll Fan1 x Duct Termination with Mesh - 400mm1 x KBA- Inlet Mounting 1801 x Vent Axia ACM 150 T (Timer Model) inline mixed flow duct fan
Reviews
Circular Inline Silencers - 0.6M long - SLU-600
Circular Inline Silencers - 0.6M long - SLU-600
£ 58.40

I have a loft mount extractor fan which was very noisy. I ...