• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Skyflow SSR Horizontal Roof Cowl SSR31/35BS1 x Bathroom Fan -Envirovent- Silent 100 T (Timer Model)1 x Helios HQW-315/4 - IP551 x CBM 12-12 1100w 6P Three Phase3 x Speed Controller - REB1-N3 x Transformer Speed Control - RTRE- 1.5Amp1 x CBM 9-9 550w 4P VR (Open Motor)3 x Duct Termination with Mesh - 355mm1 x 204x60mm Insulated Rectangular Vertical 90° Bend1 x MWS 1.5 – Transformer Controller With Motor Protection1 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt CVR1 x GRA-100 External Grill by S&P1 x MTP 10, 10K, Speed control1 x RD35S-4DW.6W.3L - 122297 (Three Phase)1 x Elta Wall Cowl SWC35/401 x HIMF - Mixed Flow Fan 100mm Inline Fan1 x CBA-100 Inlet Flange for CBT-1001 x Helios RR-250-C Centrifugal inline fan1 x Singleflow SSDL315-1EC1 x WS - Reversing Switch from Helios Fans1 x AXC TP - 100mm Plastic Centrifugal Inline Fan1 x DDMP 12-12 3F 1810W M6A4 DG02 x Elta Variable Speed Drive IP66 - 0.37KW (1ph to 3ph)1 x CBA-60 Inlet Flange for CBT-603 x Vent Axia Silent 100T (TIMER)1 x Vertical Cowl and Fan (Single Phase) - RAV400-4-11 x Elta Louvre Shutter - 400mm3 x QPTW 250C Acoustic Twin Fan with Controller1 x DS-2 2-Speed Switch (3 Phase)1 x TD Mixvent 800/200 EEXEIIT31 x Elta Wall Cowl SWC45/501 x CSB-60 Centrifugal fan1 x DA9/9-NT1 x CO2 Room Sensor - CO2-R1 x Round ceiling diffuser 200mm1 x Elta Wall Cowl SWC25/312 x Helios HQW-250/4 - IP551 x Silent 100 Window Kit - windowS1 x MTS10- extractor fan 3 step switch4 x PIR Sensor - PIR21 x Potentiometer EGH 01 - for DDMP Fans1 x Helios HQW-200/4 - IP551 x Speed Controller - REB81 x CBT-80N Centrifugal1 x TUNE-R-200-3-M0 - Control Damper (NO ACTUATOR)1 x Round ceiling diffuser 250mm1 x Comefri - TLZ 560 R - High Performance Scroll Fan1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 7101 x Commercial Single or 3 phase Fan Reversing Switch - RS11 x CK-60F Kit1 x EBM-Papst D4E225-BC01-17 Double inlet3 x Speed Controller - REB11 x Helios ESA-1 Surface mounted Speed Control 1amp1 x ENV 100 12v transformer SELV1 x Helios ZNE Electronic Fan Overrun Timer1 x UB47- Universal Insulated Terminal1 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt VR1 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt 3V (3-Speed)1 x SPI-100 C Iris damper1 x SD-MUB Vibration pad set1 x Duct Termination with Mesh - 100mm1 x VTR 500 STD Filter Kit2 x Elta 6 Amp Electronic single phase speed controller.1 x CMT-2 120/50 - 0,09Kw - LG270 Single inlet centrifugal fan direct driven1 x Transformer (silent) speed controller - RE 3.0 Amp4 x PIR Sensor - PIR41 x ACOAS/ AC/EC Auto Changeover 8Amp1 x ACO3TO-ADS-VFC-7.1A1 x WSD 100 (1060x1060x70)1 x Egg Crate Grille with G2 Dust panel filter 1 inch- 300x3002 x Compact SCD450/4-1AC1 x TG-K Duct temperature sensor1 x 100mm Round Connector with Damper1 x Helios HQW-355/4 - IP551 x KBA- Inlet Mounting 2251 x Flat Roof Terminal -OFT 5 - Asphalt1 x Elta SCP400/4-1AC - IP551 x Lo-Carbon Silhouette 100T (Timer)1 x DDMP 07/07 Mounting Flange2 x Elta - Room Sensor - Temp/Humid/C021 x REU 3amp Speed control - Two Speed Five-Step Transformer - Trickle and Boost1 x 204x60mm Insulated Rectangular Horizontal 45° Bend1 x FRQ5-10A Inverter Speed controller1 x KAD-225-F400 Rectangle Flexible Connector1 x HIMF - Mixed Flow Fan 125mm Inline Fan1 x VKS 355-500 Automatic shutter1 x ELTA - Single Phase Transformer 2amps1 x CBS-100 Outlet Flange for CBT-1001 x CBM Low Pressure Centrifugal Fan - CBM 7/7 6 Pole 72watt CVR1 x Vent Axia Trickle & Boost Switch1 x Elta Variable Speed Drive IP66 - 1.5KW1 x Quietflow Twin SQTDCV250-1ECL
Reviews
Vectaire Elegance Low Energy DMEV Fan Range
Vectaire Elegance Low Energy DMEV Fan Range
£ 131.69

I've had 2 of these fans for 4 years now, and they are great...