• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
2 x Speed Controller - REB52 x RDH FLEX-SQUARE - ADH/RDH 04505 x MTP 10, 10K, Speed control1 x Elta Louvre Shutter - 400mm2 x Silent 100 Window Kit - windowS2 x Elta Variable Speed Drive IP66 - 2.2KW2 x REB-CVF 0-10v Controller3 x Speed Controller - REB81 x TD Mixvent 800/200 EEXEIIT35 x PIR Sensor - PIR42 x SG-200 Fan Guard for the HQW 2001 x Speed Controller - REB102 x Vent Axia Silent 100T (TIMER)1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 7102 x VTR 300 STD Filter Kit2 x Silentub - STUB 1001 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt VR2 x EBM-Papst D3G133-BF05-14 Double inlet4 x QPTW 250C Acoustic Twin Fan with Controller4 x Speed Controller - REB12 x Elta Variable Speed Drive IP66 - 1.5KW1 x EBM-Papst D4E225-BC01-17 Double inlet3 x Helios HQW-250/4 - IP551 x Transformer Speed Control - RTRE- 1.5Amp1 x DA9/9-NT2 x TD160-NT Mixvent - 100mm - TD160 Timer4 x PIR Sensor - PIR23 x CBM Low Pressure Centrifugal Fan - CBM 12/12 6 Pole 736watt CVR2 x CBM Low Pressure Centrifugal Fan - CBM 9/7 4 Pole 373watt CVR3 x AIRVENT speed control - AIR4019612 x TUNE-R-200-3-M4 - Control Damper1 x KKS 100 silencer-section - For use with the MUB 100 size Fans.1 x Potentiometer EGH 01 - for DDMP Fans4 x DDMP 12-12 3F 1810W M6A4 DG01 x FRQ5-10A Inverter Speed controller1 x Jet Cowl - 315mm1 x Singleflow SSDL315-1EC3 x Elta - Room Sensor - Temp/Humid/C021 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt CVR1 x TUNE-R-200-3-M1 - Control Damper3 x Compact SCD450/4-1AC1 x Speed Controller - REB1-N1 x Quietflow SQS100-1ECL - Centrifugal Box Fan2 x SAVE VSR 300 heat recovery unit5 x CBT-100N Centrifugal2 x DS-2 2-Speed Switch (3 Phase)3 x Elta 6 Amp Electronic single phase speed controller.1 x Contactor Interface Station - CI93 x ACO8AC/EC AutoChangeover panel1 x Speed Controller - REB162 x CBA-100 Inlet Flange for CBT-1001 x Helios ZNE Electronic Fan Overrun Timer1 x Egg Crate Grille with G2 Dust panel filter 1 inch- 300x3002 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt 3V (3-Speed)1 x IR24-P - Presence detector3 x Elta Variable Speed Drive IP66 - 0.37KW (1ph to 3ph)1 x TG-K Duct temperature sensor2 x UB47- Universal Insulated Terminal2 x KMBI 225 Connector rectangular/circular to install on the discharge of CMT2 x CMT-2 225/090 1.1KW - Single inlet centrifugal fan direct driven3 x MTS10- extractor fan 3 step switch2 x CBP-18/18-RC Belt Driven Centrifugal Fans2 x RD35S-4DW.6W.3L - 122297 (Three Phase)2 x Mini Diffuser - 100mm3 x CPTA-E Flush mounted PIR sensor with timer1 x Three Phase 3 step - 10amp Transformer controller for use with the HV Wall Mounted fans.2 x Electrostatic Precipitator - 1H x 3W1 x Capacitor 2uf for use with the EBM A4E range3 x REU 7amp Speed control - Two Speed Five-Step Transformer - Trickle and Boost1 x Speed Controller - REB31 x Elta Variable Speed Drive IP66 - 4.0KW2 x Elta Variable Speed Drive IP66 - 5.5KW1 x Comefri - TLZ 560 R - High Performance Scroll Fan1 x Lo-Carbon Silhouette 100T (Timer)1 x Vent Axia ACM 100 T (Timer Model) inline mixed flow duct fan2 x Multi Input Run On Timer - 0 - 20min - CFCU2 x ELM 18 EX Flexible Cuff for ERM 181 x Round ceiling diffuser 400mm2 x HIMF - Mixed Flow Fan 100mm Inline Fan1 x Silentub - STUB 2001 x DDMP 07/07 Mounting Flange3 x Biflow SB400-CON2-3 - High Temperature Bifurcated Fan2 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt C VR1 x RSK355 - Back Draught Shutter1 x Speed controller with Reverse - REB-1R1 x Transformer Speed Control - RTRE- 5.0Amp1 x Elta Variable Speed Drive IP66 - 7.5KW1 x LFBR 315 G4 - Helios Inline Filter Box - 315mm1 x ACO3TO-ADS-VFC-7.1A1 x Helios RR-250-C Centrifugal inline fan1 x VEKA INT 2000/15.0-L1 EKO1 x Speed Controller - REB61 x VTR 500 STD Filter Kit1 x Egg Crate Grille with Dust panel filter 1 inch- 595x5951 x CMT-2 180/75 0.75KW - Single inlet centrifugal fan with inlet and outlet flange connections - 200mm1 x ACOAS/ AC/EC Auto Changeover 8Amp1 x TUNE-R-315-3-M4 - Control Damper1 x TUNE-R-200-3-M2 - Control Damper1 x DDMP 10-08 3F 2210W M6A4 DG01 x CBT-80N Centrifugal1 x KBA- Inlet Mounting 2251 x CSB-60 Centrifugal fan1 x Single Deflection Grille 400mm with OBD damper1 x CCpro 40 (1CC9402) Long Casing Extension1 x Vertical Cowl and Fan (Single Phase) - RAV400-4-11 x Round ceiling diffuser 200mm1 x Flakt Woods ME 1.3 speed controller 3amp - EA9011581 x Elta 3 Amp Electronic single phase speed controller with TK1 x AXC TP - 150mm Plastic Centrifugal Inline Fan1 x CMT-2 120/50 - 0,09Kw - LG270 Single inlet centrifugal fan direct driven1 x Single phase speed controller by auto-transformer - RMB 1.5 Amp1 x Comefri - TLZ 450 R - High Performance Scroll Fan2 x MWS 5 – Transformer Controller With Motor Protection Unit1 x TEM 075 - 5 Speed Transformer Speed Control2 x Vortice Quadro Micro 100 I - Standard Version1 x ENV 100 12v transformer SELV1 x Polyurethane Foam Media - 10PPI - Filter Media Sheets - Size: 2000mm x 1000mm
Reviews
Vectaire Elegance Low Energy DMEV Fan Range
Vectaire Elegance Low Energy DMEV Fan Range
£ 131.69

I've had 2 of these fans for 4 years now, and they are great...