• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x AIR CONDITIONING UNIT -KYR25CO/AG (Floor Standing)1 x Etaline 400mm D4-01 3-phase1 x 3 in 1 Portable Air Conditioner - 1500w1 x Etaline 400mm -EC1 x HV Wall Mounted Belt Drive Fan 1000mm 400V / 50Hz 0.75kW - Three Phase1 x Elta SLC355/4-3AC - IP551 x Helios HRFW 355/2 TK1 x Non Vision 150mm x 150mm (Air Transfer) Grille - With Flange - MILL FINISH1 x Soler & Palau - HCBT/4-1000/H-X - IP551 x Motorised Volume Control Damper - 400mm1 x FSAF355B1DX Silencer 395/81 x EC-Vent Room Unit1 x Elta SPA630/4-3EC - IP541 x Access Door 400mm x 400mm1 x Elta SCP630-1EC - IP551 x Soler & Palau - HXTR/2-250/H - IP441 x FSAF355B2DX Silencer 395/81 x Anti Vibration Mounts - Small - Pack of 4 - AVM21 x HD Series Control Damper - 2000mm X 1000mm1 x MV EC 100 Multivent1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 5001 x Duct Fast Clamps - 250mm1 x Helios HQW-250/2 - IP551 x Circular Inline Silencers - 600mm - 600mm1 x Elta Unpodded Silencer Melinex 2D-560mm1 x Elta Unpodded Silencer 1D-250mm1 x EC-Vent control board1 x Female Ducting Connector - 710mm1 x *VORT HRW 30 MONO Evo - Single Room Heat Recovery Unit,1 x Elta Wall Cowl SWC35/401 x Duct Termination with Mesh - 710mm1 x SPI-200 C Iris damper1 x EM30-24 Electro-Mechanical Control Panel1 x Elta Wall Cowl SWC25/311 x FK 125 Fast Clamp1 x Multiflow SMB500/4-1AC1 x Ducting 15 Degree Bend - 250mm1 x ACO 149-ACO1/EDV1 x AW Sileo EC Plate Axial Fan - Three Phase - 710mm1 x Hydor HPA250/2-11 x Flexible PVC Ducting - 204x601 x Male Ducting Connector - 125mm1 x GENIOX 11 Internal Mounted Unit1 x Ducting Y Piece - 125mm1 x CAB-150 ECOWATT Energy Efficient Acoustic Box Fan1 x Elta ACO Panel 149-ACO14E1 x GRA-100 External Grill by S&P1 x FSAF1250C1DA Silencer 1320/201 x OBD 450x450 - for use with 4WAY-595
Reviews
Transformer (silent) speed controller - RE 1.5 Amp
Transformer (silent) speed controller - RE 1.5 Amp
£ 125.99

Unbelievable! With TDmixvent500: noise reduction minimum 50%...