• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
3 x 204x60mm Insulated Rectangular Horizontal 45° Bend1 x 220x90mm Insulated Rectangular Vertical 90° Bend1 x Transformer Speed Control - RTRE- 1.5Amp1 x 204x60mm Insulated Rectangular Vertical 45° Bend2 x MTS10- extractor fan 3 step switch3 x CBM 12-12 1100w 6P Three Phase1 x Elta - Room Sensor - Temp/Humid/C022 x 204x60mm Insulated Rectangular Vertical 90° Bend1 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt CVR1 x Duct Termination with Mesh - 355mm3 x DEF-CBM-RE-7 - Protection Guard4 x CBA-100 Inlet Flange for CBT-1004 x SPI-100 C Iris damper3 x CBT-100N Centrifugal1 x CK-60F Kit2 x VTR 300 STD Filter Kit4 x Helios ESA-1 Surface mounted Speed Control 1amp2 x SD-MUB Vibration pad set1 x Singleflow SSDL315-1EC2 x WSD 100 (1060x1060x70)1 x AIRVENT speed control - AIR4019611 x Electrostatic Precipitator - 1H x 3W2 x CBT-130N Centrifugal ATEX II 3D ExtD 125*C1 x Contactor Interface Station - CI91 x TUNE-R-200-3-M0 - Control Damper (NO ACTUATOR)1 x Vertical Cowl and Fan (Single Phase) - RAV400-4-13 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt VR1 x CO2 Room Sensor - CO2-R2 x CFI In-line 150 - Carbon Filter2 x Helios RR-250-C Centrifugal inline fan3 x SAVE VSR 300 heat recovery unit1 x Silentub - STUB 1004 x Helios HQW-355/4 - IP551 x Duct Termination with Mesh - 100mm1 x DA9/9-NT2 x Comefri - TLZ 450 R - High Performance Scroll Fan2 x ACO8AC/EC AutoChangeover panel2 x VTR 500 STD Filter Kit1 x Flakt Woods ME 1.6 speed controller 6.0amp - EA9011593 x 100mm Round Connector with Damper1 x DS-2 2-Speed Switch (3 Phase)1 x Non Vision 150mm x 150mm (Air Transfer) Grille - With Flange - MILL FINISH1 x Round ceiling diffuser 200mm3 x CBM Low Pressure Centrifugal Fan - CBM 12/12 6 Pole 736watt CVR1 x CSB-60 Centrifugal fan2 x Round ceiling diffuser 250mm3 x CBM Low Pressure Centrifugal Fan - CBM 9/7 4 Pole 373watt CVR3 x Elta SCP400/4-1AC - IP551 x TD160-NT Mixvent - 100mm - TD160 Timer1 x Binks Bullows - Spray Booth Filter2 x Flakt Woods ME 1.1 speed controller 1amp - EA9011572 x DDMP 12-12 3F 5700W M6M0 DG71 x IR24-P - Presence detector2 x Duct Termination with Mesh - 150mm2 x KBA- Inlet Mounting 2253 x Flat Roof Terminal -OFT 5 - Asphalt2 x KAD-225-F400 Rectangle Flexible Connector1 x Flakt Woods ME 1.3 speed controller 3amp - EA9011581 x Mini Diffuser - 100mm2 x ACO3TO-ADS-VFC-7.1A1 x LFBR 160 G4 - Helios Inline Filter Box - 160mm1 x RD35S-4DW.6W.3L - 122297 (Three Phase)2 x DDMP 10-10 1F 1000W M6A2 DA52 x HIMF - Mixed Flow Fan 125mm Inline Fan1 x TUNE-R-200-3-M2 - Control Damper1 x CCpro 40 (1CC9402) Long Casing Extension2 x CBB-60N Centrifugal2 x Duct Termination with Mesh - 450mm2 x CBS-100 Outlet Flange for CBT-1001 x Potentiometer EGH 01 - for DDMP Fans1 x ACOAS/ AC/EC Auto Changeover 8Amp1 x TD Mixvent 1100/250 EEXEIIT32 x DDMP 07/07 Mounting Flange1 x Quietflow Twin SQTDCV250-1ECL2 x CAD-COMPACT 900 ADVANCED N8 - MVHR unit1 x CBM Low Pressure Centrifugal Fan - CBM 9/9 4 Pole 550watt 3V (3-Speed)4 x Biflow SB250-CON4-3 - High Temperature Bifurcated Fan1 x Elta Variable Speed Drive IP66 - 0.75KW2 x RUCK MTP 20, 10K, Speed control1 x Helios ZNE Electronic Fan Overrun Timer2 x VEKA INT 2000/15.0-L1 EKO1 x Biflow SB315-CON4-3 - High Temperature Bifurcated Fan2 x Elta HXP 800mm 6-Pole (Three Phase)1 x CMT-2 120/50 - 0,09Kw - LG270 Single inlet centrifugal fan direct driven1 x Envirovent Silent MV160/100S Mixvent - 100mm - (5 year warranty)1 x DS-2/2 2-Speed Switch IP54 (Single Phase)2 x DPD 12PM Delivery Surcharge1 x Vent Axia Trickle & Boost Switch3 x Duct Termination with Mesh - 250mm1 x CBM 7/7 147w 4P RE-VR1 x DDMP 12-09 1F 1800W M6A4 DA81 x Clearflow CF Roof Mounted Vertical Discharge Centrifugal Fan - CF315/4-1AC - Single Phase1 x 220x90mm Insulated Rectangular Horizontal 90° Bend2 x Clearflow CF Roof Mounted Vertical Discharge Centrifugal Fan - CF400/4-1AC - Single Phase1 x Elta Variable Speed Drive IP66 - 1.5KW1 x VKS 355-500 Automatic shutter1 x HIMF - Mixed Flow Fan 100mm Inline Fan1 x CBM Low Pressure Centrifugal Fan - CBM 10/8 4 Pole 373watt CVR1 x Duct Termination with Mesh - 400mm1 x Quietflow SQS250-1ECL - Centrifugal Box Fan1 x Egg Crate Grille with Dust panel filter 1 inch- 300x3001 x RDS 1 Helios Transformer Controller With Motor Protection1 x KBA- Inlet Mounting 1801 x REU 3amp Speed control - Two Speed Five-Step Transformer - Trickle and Boost1 x EFSC-3N- Single Phase Speed Control1 x FRQ5-4A V2 Inverter Speed Controller1 x Silent 300 CZ Design PLUS Extractor Fan2 x EBM-Papst D3G133-BF05-14 Double inlet1 x 125mm Round Connector with Damper1 x CBT-80N Centrifugal1 x CMT-2 180/75 0.75KW - Single inlet centrifugal fan with inlet and outlet flange connections - 200mm1 x TUNE-R-200-3-M3 - Control Damper
BD7/7 centrifugal M4 0.13Kw
BD7/7 centrifugal M4 0.13Kw
£ 345.00 now £ 300.00
Reviews
Vectaire Elegance Low Energy DMEV Fan Range
Vectaire Elegance Low Energy DMEV Fan Range
£ 131.69

I've had 2 of these fans for 4 years now, and they are great...