• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x 125mm Insulated 45 Degree Bend1 x 125mm Thermal Duct to Duct Connector - SST-125-DDCON1 x HRB/2-250-AMPN1 x 220 x 90mm Duct to Fitting Connector for use with Insulated Thermal Ducting1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 5001 x AXCBF 800D4-18 IE2 Bifurcated Axial Fans1 x Hydor HPA250/2-11 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 3551 x GB-WSD 560 Weather Protection hood for the Giga-Box Fans - 560mm1 x CTI CVA-N 500/560 Outdoor cover for CVAB/T Fans1 x GB-WSG 355 External Weather Louvers for the Giga-Box Fans - 355mm1 x Acoustic Commercial Kitchen Inline Exhaust Fan - MPS (Three Phase) - 250mm1 x Soler & Palau - HXTR/2-250/H - IP441 x CBM Low Pressure Centrifugal Fan - CBM 9/9 6 Pole 300watt VR RE1 x Belt Drive Cased Axial Fan - 450mm - L version1 x 220x90mm Insulated Rectangular Horizontal 45° Bend1 x Belt Drive Cased Axial Fan - 560mm - H version1 x Soler & Palau HXM-250mm1 x Elta SCP250/4-1AC - IP551 x Curved Blade Grille 600x600 (2way blow)1 x CTI CVA-N 450 Outdoor cover for CVAB/T Fans1 x Duct Split Rings (Pair) -1000mm1 x EZQ 20/2 B - High Performance Plate Axial Fan1 x Flexible PVC Ducting - 110x541 x Acoustic Box Fans (Inline) - CAB-355 RE1 x *VORT HRW 30 MONO Evo HCS - Single Room Heat Recovery Unit,1 x FK 125 Fast Clamp1 x Rectangular Airbrick Adaptor1 x Ducting Reducer Long - 1000mm to 710mm1 x AKOR T3/7 Spare Motor1 x 110 x 54mm Low Profile Plastic Ducting - 1 Meter1 x Elta SLC900/4A-3AC - IP551 x Pressed Ducting Saddle - 630mm1 x Female Ducting Connector - 125mm1 x GEO Ground Source Heat Exchanger1 x filter pack (set of 2) pt no. 4438891 x 220x90mm 90 Degree Horizontal Bend1 x GENIOX 11 Internal Mounted Unit
Reviews
Transformer (silent) speed controller - RE 1.5 Amp
Transformer (silent) speed controller - RE 1.5 Amp
£ 125.99

Incredible, Perfect, Silent and Fast delivery ! Thanks "Just...