• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
2 x Elta Variable Speed Drive IP66 - 7.5KW1 x FU 22 25 Frequency Inverter1 x FU 15 40 Frequency Inverter1 x FRQ5-4A V2 Inverter Speed Controller1 x Helios TSD 3.0 Transformer Speed Control (400v)1 x FRQ-10A V2 Inverter Speed controller2 x Elta Variable Speed Drive IP66 - 2.2KW2 x Elta Variable Speed Drive IP66 - 1.5KW1 x Elta 10 Amp Electronic single phase speed controller.2 x Elta Variable Speed Drive IP66 - 4.0KW1 x Frequency converter RUCK - FU 075 201 x Frequency converter FU 075 14 - IP661 x Elta Variable Speed Drive IP66 - 0.75KW1 x FU 075 52 Frequency Inverter (IP20)1 x Circular Ceiling Diffuser - TST 1251 x FU 22 04 Frequency Inverter1 x Circular Ceiling Diffuser - TST 2001 x Balance S Diffuser - NO RING - 125mm1 x Round ceiling diffuser 300mm1 x EFSC-3N- Single Phase Speed Control1 x Round ceiling diffuser 350mm1 x ELTA - Single Phase Transformer 8amps1 x Airvent ceiling fan controller2 x Push Timer Switch - ZA42 x Helios ZNE Electronic Fan Overrun Timer2 x Multi Input Run On Timer - 0 - 20min - CFCU1 x Time Delay Unit - DT20B1 x 7 Day Programmable TIMECLOCK1 x TTC-2000 Three phase electric heater controller1 x Helios - FIUK-11KW 24.0A - FREQUENCY INVERTER1 x Round ceiling diffuser 400mm2 x Elta 3 Amp Electronic single phase speed controller with TK1 x EFSC-6N- Single Phase Speed Control2 x Remote Timer Control - 13511 x Run On Timer - 5s - 4hrs - RT5A2 x ACO8AC/EC AutoChangeover panel1 x ACOAS/ AC/EC Auto Changeover 8Amp1 x MTV-1/010 Controller 0 to 10V+1 x EC-Vent control board1 x Elta ACO Panel 149-ACO14E1 x CONTROL ECOWATT - Basic1 x ACO 149-ACO1/EDV1 x EM30-24 Electro-Mechanical Control Panel1 x U-EK plastic housing IP65 - for use with the U-EK230E Motor Protection1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 5001 x EC-Vent Room Unit1 x Easy-fix termination kit - High Rise Ventilator - EFT1 x Elta ACO Panel 149-ACO18B1 x Systemair Save Connect 2.0 Internet Module1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 6301 x EM30-24 Control Panel Commissioning Service1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 3551 x REB-CVF 0-10v Controller1 x Elta Wall Cowl SWC56/631 x Transformer 5 Speed Controller - ATC1-12TK1 x Three Phase Transformer controllers - RMT 1.5 Amp1 x Vent Axia ACM 125 inline mixed flow duct fan1 x DEF-140T Inlet Guard for the CBT-100N1 x Isolator Switch - ISOSW1 x Envirovent Silent MV160/100T Mixvent - Timer Model - 100mm - (5 year warranty)1 x Electronic extractor fan speed controller - FSC 1.51 x Vent Axia T-Series Controller1 x Transformer (silent) speed controller - RE 3.0 Amp1 x Transformer Speed Control - RTRE- 1.5Amp1 x CPTA-S PIR SENSOR Volt Free Contacts - Surface Mounted1 x Quietflow SQS400-1ECL - Centrifugal Box Fan1 x MTS10- extractor fan 3 step switch1 x Multiflow SMB550/4-1AC1 x MTP 10, 10K, Speed control1 x Elta Wall Cowl SWC35/401 x QPTW 250C Acoustic Twin Fan with Controller1 x Contactor Interface Station - CI91 x Elta Wall Cowl SWC45/501 x GRA-100 External Grill by S&P1 x Helios TSW 3 Amp Transformer speed controller1 x RDS 11 Helios Transformer Controller With Motor Protection1 x COM-31 x Single phase speed controller by auto-transformer - RMB 3.5 Amp1 x TG-K Duct temperature sensor1 x MWS 1.5 – Transformer Controller With Motor Protection1 x BEAS-control module2 x Speed Controller - REB11 x CBT-100N Centrifugal1 x PIR Sensor - PIR41 x Elta Wall Cowl SWC25/311 x Elta Louvre Shutter - 400mm1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 7101 x UB47- Universal Insulated Terminal1 x CBS-60 Outlet Flange for CSB/CBT-601 x Transformer Speed Control - RTRE- 7.0Amp1 x Vent Axia Silent 100T (TIMER)1 x SAVE VSR 300 heat recovery unit1 x Silentub - STUB 1001 x Jet Cowl - 315mm1 x AIRVENT speed control - AIR4019612 x Vent Axia ACM 150 T (Timer Model) inline mixed flow duct fan1 x Vent Axia ACM 200 inline mixed flow duct fan1 x CMT-2 200/80 1.1KW - Single inlet centrifugal fan direct driven1 x KMBI 180 Connector rectangular/circular to install on the discharge of CMT2 x Bathroom Fan -Envirovent- Silent 100 T (Timer Model)1 x CBM Low Pressure Centrifugal Fan - CBM 10/10 4 Pole 550watt CVR1 x DDMP 12-12 3F 1810W M6A4 DG01 x TD160-NT Mixvent - 100mm - TD160 Timer1 x Egg Crate Grille with G2 Dust panel filter 1 inch- 300x3002 x Vent Axia ACM 100 T (Timer Model) inline mixed flow duct fan1 x Vent Axia ACM 125 T (Timer Model) inline mixed flow duct fan1 x Speed controller with Reverse - REB-1R1 x S&P MULTI-REG EC FAN CONTROLLER / INTERFACE1 x Single phase speed controller by auto-transformer - RMB 1.5 Amp1 x Commercial Single or 3 phase Fan Reversing Switch - RS11 x CBA-60 Inlet Flange for CBT-601 x TD Mixvent 800/200 EEXEIIT31 x ERR 20/1 Centrifugal inline fan1 x Speed Controller - REB2.5-N1 x CBM Low Pressure Centrifugal Fan - CBM 12/12 6 Pole 736watt CVR1 x Mini Diffuser - 100mm2 x Transformer 5 Speed Controller - ATC1-2TK1 x Speed Controller - REB51 x DA9/9-NT1 x Egg Crate Grille with Dust panel filter 1 inch- 595x5951 x Helios RR-250-C Centrifugal inline fan1 x Transformer 5 Speed Controller - ATC1-10TK
Reviews
Circular Inline Silencers - 0.6M long - SLU-600
Circular Inline Silencers - 0.6M long - SLU-600
£ 58.40

I have a loft mount extractor fan which was very noisy. I ...