710mm Spiral

710mm Curved Boot - Comes with 450mm spigot Pressed and seam welded safe curved shoe. ...

710mm Duct split rings for solid or semi flexible ducting, Can be used to hang from a ceiling or mount onto the wall securing the ducting in place....

710mm Angled exhaust take-off (with bird mesh) at 45 Degrees, designed for terminating round ducts. Also known as Birdbeaks. Shipping cost for this product is based on Volumetric Weight This ...

710mm Ducting 30 Degree fabricated, without gasket. Shipping cost for this product is based on Volumetric Weight This item's shipping weight is relative to the dimensions and the means of trans...

710mm Ducting 45 Degree fabricated bend, seam-welded and calibrated, without gasket. Shipping cost for this product is based on Volumetric Weight This item's shipping weight is relative to the ...

710mm Ducting 90 Degree fabricated bend, without gasket. Shipping cost for this product is based on Volumetric Weight This item's shipping weight is relative to the dimensions and the means of ...

Long Reducers for 710mm spiral ducting. Provides two male fittings to insert into spiral. Select size below. Please note these are for reducing and fitting inside ducting. To mount directly onto a ...

710mm Ducting Equal T-Piece Vent tee piece built with a saddle or a fully pressed top section, all connections the same size. Shipping cost for this product is based on Volumetric Weight Th...

A 710mm Female coupling connector for joining fittings together or to a fan unit. To Join two pieces of ducting together, you will need the CONM - Male Ducting Connector...

A 710mm Spigot ring or take-off vent, without radius and gaskets, for connecting to ducting. Provides a male ducting connection so inserts into spiral. Designed for installation in the walls of rect...

A 710mm male coupling connector for joining two pieces of ductwork together. Can also be used with hose clips to join lengths of flexible ducting....

Connects a duct to a wall face or rectangular ductwork, provides a 710mm male spigot surrounded by a 800mm square plate of steel....

710mm Zinc-plated Mild Steel Spiral Tube used for ventilation systems. Spiral ducting is manufactured 0.6mm of Zinc-plated Mild steel to HVCA DW 144 Specification unless otherwise stated. An alter...

710mm Zinc-plated Mild Steel Spiral Tube used for ventilation systems. Spiral ducting is manufactured 0.6mm of Zinc-plated Mild steel to HVCA DW 144 specification unless otherwise stated. An a...