• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,438.15 (excl. VAT)

£ 4,125.78 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x HIMF - Mixed Flow Fan 100mm Inline Fan1 x Jetflow-HIT Metal inline - 160mm1 x HQS Bathroom Axial Flow Fan - 125mm1 x Elta - SMT 125 Mixvent Inline Fan - Clearance Stock Line2 x Hydor Typhoon Circulation Fans - HVFB - 300mm1 x DV-ROF-V-225 Roof mounted unit1 x Fresh Air control carbon filter - 125mm1 x Ducting 90 Degree Bend - 355mm1 x Duct Termination with Mesh - 355mm1 x Etaline Max-Fan - 315mm - E2 011 x Spigot plate - 355mm1 x Flanged Spigot - 355mm1 x Female Ducting Connector - 355mm1 x Duct Fast Clamps - 355mm1 x Mellizo XL EcoWatt 3000 - Twin Fan1 x Commercial Activated Carbon Filters - Panel Type - 20" x 20" x 1 - ACP1 x CAB-200 ECOWATT Energy Efficient Acoustic Box Fan1 x Activated Carbon Discarb Cell - Grade 50 - EXTRA DUTY - 445H x 445W x 595Dmm ACTUAL1 x HRB/4-500-30-APNC1 x Spiral Ducting 1 meter - 800mm1 x GORDON W 30/12″ ET Oscillating wall mounted fan with remote control1 x HRB/6-500-25-APN1 x Hydor Typhoon Circulation Fans - HVFB - 450mm1 x Elta Quietflow Twin SQT500-1ECL1 x CFI In-line 3000 - Carbon Filter1 x Spigot plate - 800mm1 x MELL-USD 3000 Rectangular to Circular Adaptor 355 Dia1 x Elta Wall Cowl SWC45/501 x Elta SCP500/4-1AC - IP551 x Classic SAX30/12AR Window/Wall Mounted1 x Ancillary Pack for SB-Biflow 400 model1 x Etaline 200mm1 x Vent Axia KAF Kitchen Extract Fan - 450mm - 2 Pole - Single Phase1 x Ducting 15 Degree Bend - 150mm1 x Classic SAX23/9A Window/Wall Mounted1 x HD-LL Series 600x6001 x KVK Slim 125 - Low profile Semi Acoustic Box Fan1 x HD-LL Series - 100mm with NFA-S2, Multi Voltage Damper Actuator1 x Motorised Volume Control Damper - 400mm1 x SPI-125 C Iris damper1 x 125mm Round Equal T Piece1 x filter pack (set of 2) pt no. 4438891 x Genius Whole house unit -
Reviews
Duct Mounted Inline Filter - EU4
Duct Mounted Inline Filter - EU4
£ 41.95

Well made and robust, but it was not use for my application ...