• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x 7 Day Programmable TIMECLOCK1 x REB-CVF 0-10v Controller1 x CONTROL ECOWATT - Basic1 x Easy-fix termination kit - High Rise Ventilator - EFT1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 6301 x Elta ACO Panel 149-ACO14E1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 5001 x EM30-24 Electro-Mechanical Control Panel1 x ACO 149-ACO1/EDV1 x U-EK plastic housing IP65 - for use with the U-EK230E Motor Protection1 x EC-Vent Room Unit1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 3551 x Elta Wall Cowl SWC56/631 x Single Deflection Grille 400mm with OBD damper1 x Non Vision 150mm x 150mm (Air Transfer) Grille - With Flange - MILL FINISH1 x Economy Airvent 150mm Fan With Pullcord & Shutters1 x Economy Airvent 100mm Fan with Timer & Shutter2 x HIMF - Mixed Flow Fan 125mm Inline Fan1 x DPD SATURDAY Delivery Surcharge1 x Control board kit Smarty 4X P 1.1 F2 Fan 230V2 x HQS Bathroom Axial Flow Fan - 125mm1 x 204x60mm Rectangular to 100mm Round Adaptor1 x CTVT/4-400 High Temp Roof Fan - 51369260001 x Manrose XF100HTLVT- Clearance2 x Jetflow-HIT Metal inline - 125mm1 x Maico EN31- Wall Mounted Fan1 x Capacitor 2uf for use with the EBM A4E range2 x H14 Hepa Portable Air Purifier - PAP 350 CA H14 with Carbon Filter2 x HIMF - Mixed Flow Fan 100mm Inline Fan1 x 110 x 54mm Short Rectangular to Round Adaptor male1 x LF-ME04F071LC3AC1 x Fresh Air control carbon filter - 125mm1 x Jetflow-HIT Metal inline - 160mm1 x DV-ROF-V-315 Roof mounted unit1 x Carriage for Scottish Highlands1 x Direct Delivery Surcharge - Pre 12:001 x IRAB/4 315A N 230V50Hz 355/100 VE - In-Line Duct Fans - 51329333002 x HRB/6-451/20-BMVPN - Special Offer1 x Manrose 150mm - XF150BTP1 x BD9/9 centrifugal M4 0.35Kw1 x BD7/7 centrifugal M4 0.13Kw1 x 125mm Round 45 Degree Bend1 x Ducting 90 Degree Bend - 150mm1 x Direct Delivery Surcharge1 x Elta - SMT 125 Mixvent Inline Fan - Clearance Stock Line1 x Elta Unpodded Silencer Melinex 1D-500mm1 x Helios DDF-200 Roof Cowl1 x Ducting 90 Degree Bend - 200mm1 x Soler & Palau TCBT/2-315/H-B E70 - IP551 x Roof Axial Cowl - RAW8001 x Elta Unpodded Silencer 1D-250mm1 x CMT-2 120/50 - 0,09Kw - LG270 Single inlet centrifugal fan direct driven1 x G2 duct Mounted Panel Filter - 595 x 525 x 22mm1 x FSAF1000C1DA SILENCER 1070/161 x Helios AV125 External Wall Fan1 x Circular Inline Silencers - 600mm - 600mm1 x Helios DDF-315 Roof Cowl1 x Flat Roof Terminal -OFT 5 - Asphalt1 x Elta Podded Silencer 2D- 710mm1 x Roof Axial Cowl - RAW630 / 7101 x Roof Axial Cowl - RAW3151 x Elta Podded Silencer 2D- 900mm1 x Roof Axial Cowl - RAW10001 x Soler & Palau VFD-T inverter 5 amp IP541 x CBA-60 Inlet Flange for CBT-601 x AL 1120 Mounting Flange1 x Soler & Palau - HCBT/6-710/H - IP651 x CAD-COMPACT 500 ADVANCED N8 - MVHR unit1 x CBA-160 Inlet Flange for CBT-1601 x A Duct Mountable - Double Drilled Fixing Flange (PAIR) - 630mm1 x CBS-160 Outlet Flange for CBT-1601 x A Duct Mountable - Double Drilled Fixing Flange (PAIR) - 710mm1 x CBS-130 Outlet Flange for CBT-1301 x Elta Unpodded Silencer 2D-500mm1 x A Duct Mountable - Double Drilled Fixing Flange (PAIR) - 500mm1 x ASF 355-500 inlet flange DVS1 x GEO Ground Source Heat Exchanger1 x A Duct Mountable - Double Drilled Fixing Flange (PAIR) - 450mm1 x Casals Circular Outlet Connection Flange - 5102018031 x 14500170 - A - Outlet Flange for THLZ FF 4501 x EnergiSava 210 Low Energy Heat Recovery Unit1 x Vent Axia ACM 100 T (Timer Model) inline mixed flow duct fan1 x TDP-D Pressure Sensor with Display1 x Transformer 5 Speed Controller - ATC1-4TK
Reviews
Airvent Ceiling Sweep Fan - 36 inch - 444122
Airvent Ceiling Sweep Fan - 36 inch - 444122
£ 59.84

Fitted 2 Of These Excellent Fans in a Community Club to shif...