• Model:GEOGroundS

GEO Ground Source Heat Exchanger

£ 3,610.06 (excl. VAT)

£ 4,332.07 (inc. VAT)

In the winter, domestic heat recovery units switch to a frost protection mode at low temperatures outside.This usually means that the supply fan slows down, causing an imbalance between the supply and exhaust air through the heat recovery unit. Another possibility is that a (pre-) heater is turned on, which usually consumes 1 to 2 kW of energy. In the summer, at high external temperatures, the supply air from outside can be warmer than the air inside the house. Therefore, this warm supply air can increase the temperature in the house which is undesirable.

The horizontal ground heat exchanger GEO can offer a solution for the problems mentioned above, using a minimum of energy.

GEO has its own control which can be used in combination with any type of heat recovery unit. This control will start the highly energy efficient pump of the GEO at specific set outside temperatures, causing the liquid to flow through the duct. The temperature of the liquid, will approach the temperature of the soil and will transfer its energy to the supply air of the heat recovery system through the battery of the GEO.

By using GEO, the efficiency of the heat recovery can be increased.

Benefits:
• With 8W energy, you can gain up to 1.5 kW.
• Can be used in combination with any heat revocery unit up to 300m³/h.
• Increases the efficiency of the heat recovery unit.
• Has its own control, allowing energy consumption only when needed.
• Has an A label-EC pump and a G4 filter for the protection of the heat exchanger.
• Is easy to install, all in 1 case (pump, control, sensors, filters, filling and venting unit, battery, gauge, vent valve, volume meter, and pressure vessel).
• Has a right / left version in 1 unit and the air to the heat recovery unit can be mounted both on the top and on the side.
• Thanks to relatively thin duct (DN32), it is easy to install.
• Is an hygienic and attractive solution.
• Is easy to clean: condensation develops in the GEO, which is led to the sewer through the condensate drain.
1 x Elta Cased Axial Flange - 400mm1 x Spiral Ducting 3 Meters - 400mm1 x TTC-2000 Three phase electric heater controller1 x ACOAS/ AC/EC Auto Changeover 8Amp2 x ACO8AC/EC AutoChangeover panel1 x EC-Vent Room Unit1 x U-EK plastic housing IP65 - for use with the U-EK230E Motor Protection1 x Elta Wall Cowl SWC56/631 x Ancillary Pack for SLC-4001 x CBMT/Q 400-55 1 HEATER KIT1 x Duct Mounted Filter Box - G4 Grade Panel - 400mm1 x MWS 5 – Transformer Controller With Motor Protection Unit1 x Easy-fix termination kit - High Rise Ventilator - EFT1 x Elta ACO Panel 149-ACO18B1 x S & P Aluminium Axial Fan Louvre Shutter - PER-CR- 3551 x Elta Wall Cowl SWC35/401 x Round ceiling diffuser 400mm1 x Jet Cowl - 315mm1 x Egg Crate Grille with G2 Dust panel filter 1 inch- 300x3001 x Egg Crate Grille with Dust panel filter 1 inch- 595x5951 x Single Deflection Grille 400mm with OBD damper1 x Non Vision 150mm x 150mm (Air Transfer) Grille - With Flange - MILL FINISH1 x Mini Diffuser - 100mm1 x Egg Crate Grille with Dust panel filter 1 inch- 300x3001 x DPD 12PM Delivery Surcharge1 x Same Day Shipping Surcharge - City Sprint1 x Northern Ireland Pallet Surcharge1 x Vent Axia ACM 150 T (Timer Model) inline mixed flow duct fan1 x Transformer 5 Speed Controller - ATC1-4TK1 x REU 7amp Speed control - Two Speed Five-Step Transformer - Trickle and Boost1 x TDP-D Pressure Sensor with Display1 x Helios TSW 1.5 Amp Transformer speed controller1 x Helios TSW MCB Amp Transformer speed controller1 x RTRD - Three Phase Speed Controller - 7 Amp1 x Helios TSW 10 Amp Transformer speed controller1 x Vent Axia ACM 125 inline mixed flow duct fan1 x TG-K Duct temperature sensor1 x TEM 035 - 5 Speed Transformer Speed Control1 x Two Speed Switch - REGUL-21 x Transformer (silent) speed controller - RE 3.0 Amp1 x Transformer Speed Control - RTRE- 12.0Amp1 x FAST-TRACK RANGE 90mm - Adaptor For Distribution Box1 x Electronic extractor fan speed controller - FSC 1.51 x Speed Controller - REB101 x FAST-TRACK RANGE 90mm - Click Ring (1 bag of 10)1 x Rectangular Airbrick Adaptor1 x Speed Controller - REB1-N1 x TD Mixvent 1200/315 EEXEIIT31 x Commercial Single or 3 phase Fan Reversing Switch - RS11 x FAST-TRACK RANGE 75mm - Click Ring (1 bag of 10)1 x REB-CVF 0-10v Controller1 x MTP 10, 10K, Speed control1 x Speed Controller - REB11 x Transformer Speed Control - RTRE- 1.5Amp1 x Quietflow SQS400-1ECL - Centrifugal Box Fan1 x DEF-CBM-RE-7 - Protection Guard1 x PIR Sensor - PIR41 x CMT-2 225/090 1.1KW - Single inlet centrifugal fan direct driven1 x ELM 25 EX Flexible Cuff for ERM 251 x ELM 20 EX Flexible Cuff for ERM 221 x QPTW 250C Acoustic Twin Fan with Controller1 x GXC6EC - High Performance Extract Fan1 x AIRVENT speed control - AIR4019611 x SAVE VSR 300 heat recovery unit1 x FAST-TRACK RANGE 75mm - Adjustable Air Restrictor1 x Electrostatic Precipitator - 1H x 3W1 x CK-60F Kit1 x CMT/4-315/130-4KW - Single inlet centrifugal fan direct driven1 x IR24-P - Presence detector1 x Duct Termination with Mesh - 100mm1 x Potentiometer EGH 01 - for DDMP Fans1 x Vent Axia ACM 100 T (Timer Model) inline mixed flow duct fan1 x Remote controller FLEX - for VEKO INT1 x Helios TSW 7.5 Amp Transformer speed controller1 x REU 1.5amp Speed control - Two Speed Five-Step Transformer - Trickle and Boost1 x Transformer 5 Speed Controller - ATC1-10TK
Reviews
DAOSL Back Draft Damper
DAOSL Back Draft Damper
£ 11.49

Look good, works well, except the shaft of the lanellae cuts...